Yamato MPT 260 Manual De Instrucciones página 22

cod. 81330 Mod. MPT 260 ENGLISH
Do not use sanding paper intended for larger sanding pads. The larger sanding paper will
extend beyond the sanding pad, causing smudging, paper tearing, or kickback. Extra
paper that extends beyond the sanding pad can also cause severe tears.
WARNING! Dust generated by electrically powered sanding, cutting, grinding, drilling and
other construction activities contains chemicals that cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead, from lead-based plants;
• thin slices of crystalline material, from brick and concrete and other masonry products e
• arsenic and chromium, from chemically treated wood.
The risk from these exposures varies according to the frequency with which this type of
work is performed. To reduce exposure to these chemicals, it is recommended to work in a
well-ventilated area, wearing approved safety equipment, such as dust masks specially
designed to filter out microscopic particles.
Use of the appliance
Warning! Disconnect the plug from the socket before carrying out any assembly,
adjustment or replacement of accessories. These preventive safety measures reduce the
risk of accidental starting of the appliance.
Be very careful and use personal protective equipment, especially protective gloves,
when mounting sharp tools.
Functional description
Assembly
Turn off the power switch and unplug the appliance.
Lift and then rotate the quick release lever 180 degrees (II).
Install the work tool intended for the appropriate type of work. Install the work tool in the
shaft bracket so that you can work as easily as possible, but safely.
Warning! It is forbidden to mount the blade with the (cutting edge) in the direction of the
operator
Make sure that the holes in the blade match the pins in the shaft holder (III).
Warning! Mounting the blade with less than two pins is prohibited.
Warning! Work tools can be mounted with both open and closed clamps.
The lever of the quick assembly mechanism has a guard that does not allow the
operator's fingers to be pinched when the lever is closing.
Before fully lowering the lever, the pin must be moved to a position that allows the lever to
close (IV).
Rotate the quick-mount lever 180 degrees to allow the working tool to be mounted in the
shaft bracket.
Quickly tighten the mounting lever to protect it from accidental opening during operation
(IV).
Warning! The sanding pad can be equipped with a washer located in the mounting hole
that you must remove with a small screwdriver before mounting the sanding pad.
Abrasive disc assembly (V)
When selecting the sanding pad as a work tool, the sanding disc must be installed before
starting work.
The backing pad has Velcro on which the abrasive disc must be mounted so that the
edges of the disc match the edges of the backing pad.
Assembly of the additional handle (VIII)
22