Cleaning And Maintenance - Mx Onda MX-CDP2686 Manual De Usuario E Instalacion

With the range hood turn on and the engine running, touch and hold your finger
on the light on / off button 3 ( ), an acoustic warning will sound and clock 6
will flash the switch-off time " 10:00 " ten minutes.
When the sleep time is flashing, repeatedly touching the 3 ( ) button will
increase the sleep time.
After choosing the sleep time, allow 3 seconds to elapse without touching any
button and the sleep timer will start.

CLEANING AND MAINTENANCE

Before cleaning, disconnect the extractor hood from the mains, turn off the
omnipolar isolation switch or unplug it from the mains socket.
Cleaning the outside and inside of the range hood
Clean the outside and inside with a damp cloth with warm water and
degreasing soap, then dry them carefully.
Do not use scourers, alcohol or abrasive products and do not allow the
appliance to come into contact with volatile agents such as gasoline, solvents,
insecticides, etc.
Cleaning the filters
To remove the filters, press the retention tabs and gently pull the filters down.
Soak the filters in hot water with degreasing soap and let the solution work,
then rinse the filters with hot water and let them dry.
If you wish, you can use specific products with high degreasing power to
remove grease, in which case you should read the instructions for the
degreaser product and follow the advice for use.
Do not put wet filters in the hood, make sure they are completely dry before
putting them back.
Do not use abrasive or metal scourers that can scratch the surfaces, use
specific products for grease.
To insert the filters into the hood, match the fixed tabs (the ones opposite the
retainer) into the grooves of the cooker hood, then press the retaining tabs and
snap the filter into place by releasing the retaining tabs. Make sure the filters
are properly retained.
8