Mx Onda MX-CDP2686 Manual De Usuario E Instalacion página 44

5. Placement of the sections that form the chimney
a) Check that the range hood works correctly.
b) Insert the second section of the chimney so that it is inserted inside the
first section of the chimney and is glued to the ceiling, then fix it to the
support using the supplied screws A.
REPLACING THE LED BULBS
The hood LED bulbs must only be replaced by an Official Technical Service or
by qualified personnel. To change the LED bulbs:
1. Before proceeding with the replacement of the LED bulbs, disconnect the
cooker hood from the mains, turn off the omnipolar isolation switch or
unplug it from the mains socket.
2. Remove the filters to access the interior of the cooker hood.
3. The bulbs are held by pressure plates, so by applying a slight pressure
from the inside of it towards the outside the bulb will come out, then
disconnect the power connector from the bulb to be able to extract it
completely.
4. Insert the new bulb with slight pressure on it and reconnect the power
connector.
Note: Use original accessories, otherwise it could damage the cooker hood
and the warranty will not be valid.
14