Mx Onda MX-CDP2686 Manual De Usuario E Instalacion página 40

2. Installation of the chimney supports (first section)
The chimney of the range hood is made up of two pieces, which are
inserted one inside the other to adapt to the height between the ceiling and
the main body of the range hood.
a) Fix the support A using the metric thread B screws to the first section
of the chimney (the one without ventilation grilles).
b) Fit the first section of the chimney into the main body of the extractor
hood, make sure that it is correctly fitted.
c) Mark the two holes C of the chimney bracket.
d) Drill two 10 mm Ø holes at marks C.
e) Insert the supplied plugs D.
f) Place the first section of the chimney with the support and fix it to the
wall using the screws E supplied.
10