Cequent Performance Products 24764 Instrucciones De Instalación

Spare Tire
Hitch Shown In Proper Position
Equipment Required: Utility Knife
Fastener Kit: 24764F
Wrenches: 19 mm, Torque Wrench
Drill Bits: N/A
License Plate Mounting Location
8"
Figure 1.
j
Qty. (4) Hex Bolt, M12 x 1.25 x 35mm CL8.8
k
Qty. (4) Conical Toothed Washer ½
1. Notify vehicle owner that the fascia requires minor trimming to fit hitch.
2. Using a felt tipped pen, measure and mark an outline on the fascia described in Figure 1.
3. Using a utility knife, carefully cut out the fascia on the bottom inside section of the license plate mounting area as shown.
4. Raise hitch into position, aligning the holes in hitch with the two rearmost weldnuts in the bottom of frame rail, both sides.
5. Loosely install the M12 hex bolts and conical toothed washers, four places.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2013, 2015 Cequent Performance Products – Printed in Mexico
Installation Instructions
Suzuki Grand Vitara
(Sold separately)
Drawbar Kit:
Fascia
Drawbar must be used in the
RISE position only.
3/4"
Fascia
1-1/4"
Area to Trim
Tighten all M12 CL8.8 fasteners with torque wrench to 76 Lb.-Ft. (102 N-m)
3591
Do Not Exceed Lower of Towing Vehicle
Frame Rail
Sheet 1 of 3 24764N
Part Numbers:
24764
77140
60827
24499 U-Haul
Manufacturer's Rating or
2000 LB (907 Kg.) Max Gross Trailer Weight
200 LB (90 kg.) Max Tongue Weight
Wiring Access Location: SUV3, SUV4
Existing
Weldnuts
Typ.
2
Figure 2.
1
10-13-15 Rev. C