Flotec EP2-04 Manual Del Usuario página 4

Installation / Electrical
DISCHARGE PIPE CONNECTION
(FIGURE 2)
Connect the 5-way tank tee to your plumbing system.
Snifter Valve
Flow
1" PipeTo
Household
Water System
Pressure
Switch
Priming
Port
Discharge
Port
Flow
Priming
Check Valve
Tee
(Purchase
Separately)
1" Pipe From
Water Source
Water Level
Foot Valve
Figure 2 – Suction and discharge connections for Model
EP2-04.
Use only teflon tape for making all threaded connections to the pump itself. Do not use pipe joint compounds
on plastic: they can react with the plastic. Make sure that all pipe joints in the suction pipe are air tight as well
as water tight. If the suction pipe can suck air, the pump will not be able to pull water from the water source.
WIRING CHART – RECOMMENDED WIRE AND FUSE SIZES
Volts/ Maximum
Hz./
Model Phase
EP2-04 115/50/1
* When using fuses, dual element or Fusetron time delay fuses are recommended for all motor circuits.
For parts or assistance, call Flotec Customer Service at
Tank
Adapter
5-Way Tank Tee
Pressure
Gauge
Pump Intake
Port
4555 0304
Sealing Pipe Joints
Branch
Load Circuit Breaker
Amps Rating (Amps)*
5.8 15
ELECTRICAL
Hazardous voltage. Risk of dangerous or
fatal electric shock. Plug the pump into a 115 Volt, 60
Cycle, Ground Fault Circuit Interrupter (GFCI) protect-
ed grounded outlet only. The pump is equipped with a
3-wire, grounded, cord and plug. Do not modify or
remove the plug. Make sure the pump circuit meets all
codes and ordinances that apply. To avoid dangerous
electrical shock hazard, keep the cord dry at all times.
Lubrication
The motor is lubricated at the factory for the life of
the bearings. The pump seal is water cooled and self
lubricating.
Pump Service
Hazardous voltage. Can shock, burn, or
cause death. Unplug the pump before servicing it. Do not
handle the pump or attempt to work on the pump with
wet hands or while standing on a wet or damp floor.
The motor has an auto-reset thermal overload protector.
If the motor overheats, the overload will cut off the
power to prevent damage and will reset after the motor
cools. If the overload trips repeatedly, check the pump
for the cause (low voltage, a clogged impeller, etc.).
Distance in Feet (m) from Motor To Supply
Wires Sizes AWG (mm
0-100 (0-30) 101-200 (31-61) 201-300 (62-91) 301-400 (92-122)
14 (2) 14 (2)
1-262-728-5551
4
)
2
12 (3) 10 (5.5)