Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING, PLACE INFLATOR
ON A HARD, CLEAN SURFACE • WEAR GLOVES AND SAFETY GLASSES WHILE
OPERATING INFLATOR
1. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool
approximately 15 minutes between uses. Do not leave inflator unattended.
2. DO NOT run vehicle while inflator is operating. Engine must be turned OFF. Always
ensure air hose connector is secured on the valve stem for proper inflation.
3. ALWAYS use a pressure gauge to check actual tire pressure. DO NOT OVERINFLATE!
4. Read all instructions thoroughly before use. Failure to follow warning instructions
can result in fire, injury to persons or property damage.
5. For use with 12-volt DC power batteries.
TO INFLATE TIRES:
1. Attach twist-connect air fitting to
inflator, then screw the opposite
end connector onto tire's valve stem
2. Attach battery clips to battery,
positive side first.
3. Switch inflator "ON",
and inflate tire to manufacturer's
recommended air pressure.
When proper pressure is reached, turn off
inflator and disconnect power cord, ground
side first.
Replace batteries on back of light.
Publicidad
