Slime 40028 Instrucciones página 4

HOW TO INFLATE TIRES:
1. Attach air hose to tire by fully screwing the
connector onto the tire valve.
2. Plug power cord into power accessory outlet or
leave unplugged to run from battery.
NOTE: The unit will not run unless the gauge is
turned on by pressing the "set" button.
3. To set the Inflate-Right™ system, press either arrow
button under the display for 3 seconds until the
target pressure blinks.
4. Use the up and down arrow buttons to reach your
target pressure. The inflator will store this pressure
automatically after a few seconds.
5. To inflate, press the button with the tire symbol.
Once your target pressure is reached, the inflator
will shut off. The inflator can be manually shut off
by pressing the tire symbol button again.
6. Unplug power cord (if necessary) and disconnect
the air hose.
NOTE: Correct tire pressure can be found in vehicle's
owner manual or driver's side door jamb.
TO TOGGLE PRESSURE UNITS (PSI/kPa/BAR):
Press the "Set" button at the base of the gauge.
HOLD FOR 3 SECONDS
TARGET PRESSURE