Installation Instructions - Slime SMART SPAIR Instrucciones

INSTALLATION INSTRUCTIONS

Repairing a flat tire with a Smart Spair is simple and takes only 15 minutes
1
5
1. Start by rotating tire so that the valve stem is in the upper half of the tire.
2. Slowly remove the valve core with valve core tool provided. Take care to keep a hold of the
valve core as remaining pressure in the tire can cause the core to shoot out.
3. Allow the tire to fully deflate.
4. Remove the puncturing object if possible.
5. Place white cap on sealant bottle. Attach filler tube to the bottle tip and tire valve stem
and squeeze in recommended amount of Slime Tire Sealant.
6. Replace the valve core.
7. Inflate the tire.
STEP 1
Place connector on
air valve stem and
push down.
*NOTE: Correct tire pressure can be found in vehicle owner's
manual or on driver's side door jamb.
8. Drive for .2 mi (.32km) and stop to verify that the puncture has been sealed.
Check tire pressure. Reinflate if necessary.
2
6
STEP 2
Close thumb
latch connector to
secure to valve.
3
7
STEP 3
Plug power cord into power
outlet receptacle
.
4
0.2 MI/0.32 KM
PSI
BAR/KPA
8
STEP 4
Turn on inflator and
when proper pressure
is reached, turn off
inflator, unplug power
cord and remove
connector.