Cequent Performance Products 76026 Instrucciones De Instalación página 5

2. Fascia removal – (b) Use screwdriver to remove (2) screws from wheel well each side. Behind the wheel well, use T20 torxbit
socket to remove (2) screws and screwdriver to remove (4) screws each side. (c) Use plastic trim tools to remove the fascia
starting at the outer edges near the wheel wells and gently pull the fascia. Disconnect wiring harness on driver side if present.
3. Bumper beam removal - Use 8 mm socket to remove (5) screws from the panel above bumper beam, see Figure 2. Use 21 mm socket to remove (4) M14
factory bolts from bumper beam each side. Gently remove the panel and bumper beam and set them aside. Return bumper beam to vehicle owner.
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 5 of 18 76026NP 03-14-17 Rev. A