Cequent Performance Products 76026 Instrucciones De Instalación página 6

4. Hitch installation - Use silicone sealant to seal around the opening on the end panel each side, see Figure 3. Raise the hitch into position and align it
with bumper end panel holes. Loosely secure the hitch to the bumper end panel using (8 ) existing M14 factory bolts removed in Step 3, see Figure 1.
5. Tighten all M14 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M).
6. Bottom appearance panel trimming – locate the center of bottom panel and trim 6.0'' tall by 3.5'' wide area, see Figure 4.
7. Reinstall all fasteners, bumper panel, plastic cover piece, fascia, and appearance bottom panel removed in Step 1, 2, 3.
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico
3.5''
6.0''
Proper torque is needed to keep the hitch
secure to the vehicle when towing.
Sheet 6 of 18 76026NP 03-14-17 Rev. A