Cequent Performance Products 76023 Instrucciones De Instalación página 4

1. Fascia door and fascia bottom support brackets removal - use 7 mm socket to remove (2) bolts from
bottom fascia door, see Figure 2. Use 7 mm socket to remove (3) bolts from bottom fascia support
bracket each side and unclip the plug if present. Return bottom fascia support brackets to owner.
2. Fascia removal - open the trunk and use 7mm socket & T15 driver to remove (2) bolts as shoen in Figure 3. Use phillips screwdriver and T15 driver to remove (3) bolts from plastic
mud flap each side. Use T15 driver to remove (1) bolt from bottom fascia, and (1) bolt from wheel well liner each side. Gently pull off the upper wheel well body trim piece and remove
(2) bolts behind it with 7 mm socket each side, see Figure 4. Gently remove the fascia and attachment straps behind wheel well liner. Unplug the wiring on driver side if present.
Carefully set the fascia and straps aside for reinstallation.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 4 of 15 76023NP 07-07-16 Rev. A