Cequent Performance Products 76080 Instrucciones De Instalación página 5

Gently pull off vehicle bumper fascia. Note: Plastic body panel removal tools suggested
to ease removal. You will need to disconnect/unplug the electric connector on the
passenger side. Set the bumper fascia aside.
Raise hitch and bumper beam into position aligning holes with studs in the vehicle end
panel. Sandwich the hitch between the bumper beam and the end panel. Re-use
existing nuts. See Figure 1.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Remove the bumper beam by removing (4) nuts each side with a 15mm socket.
Tighten all hitch fasteners with torque wrench to 38 Lb.-Ft. (52 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 5 of 18 76080NP 7-15-16 Rev. A