Publicidad
Idiomas disponibles
Idiomas disponibles
4. Trim heat shield – Using metal shears, trim the heat shield as shown.
See figure 2.
6. Install fasteners – Feed the coiled end of pull wire through the second attachment hole and out of the forward most access hole in the bottom of frame. Attach
the 7/16" carriage bolt and ¼" thick spacer block (item 2) to the pull wire and pull the fasteners into position, both sides. Repeat process for the middle
attachment, both sides. Make sure the spacer blocks are sitting flat inside the frame and do not overlap. See figure 3.
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico
Area to Trim
Heat shield
5. Reinstall heat shield – Reinstall heat shield using (3) of the screws
removed in step 2.
Sheet 5 of 21
24960NP
3-21-17
Rev. A
Publicidad
