Publicidad
Idiomas disponibles
Idiomas disponibles
7. Install forward most fasteners – Using the reverse fish wire method,
attach the 7/16" carriage bolts and ¼" thick spacer blocks (item 2) to the
pull wire and pull the fasteners into position, both sides..
B. Align block on
A. Insert bolt and
Block into frame
9. Install hitch – raise hitch into position being careful not to push fasteners back into the frame. Using an 11/16" socket, loosely install the 7/16 conical toothed
washers and 7/16-14 hex nuts onto carriage bolts, (6) places. Make sure the 1/8" space blocks (item 3) are sitting flush against the bottom of the frame and are not
on the raised area of frame. If necessary, adjust the hitch towards the driver's side to provide more clearance between the hitch and muffler. Torque fasteners to
specifications below.
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico
C. Pull bolt thru
access hole
block
8. Attach spacer blocks – using tape, secure the 1/8" thick spacer blocks
(item 3) to the top of hitch brackets at the forward most attachment, (1)
per side.
Figure 5
Sheet 6 of 21
24960NP
3-21-17
Rev. A
Publicidad
