Sauder 410287 Manual Del Usuario página 9

Step 4
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the
å
ENDS (A2 and B2) until the shoulders of the SCREWS rest
on the surfaces of the ENDS.
Slide the END MOLDINGS (J) onto the ENDS (A2 and B2).
å
Line up the grooves in the MOLDINGS over the heads of the
SCREWS in the ENDS.
NOTE: The MOLDINGS should be centered on the ENDS.
å
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
These edges
should be even.
www.sauder.com/services
A2
J
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
B2
Shoulder
32S
410287
These edges
should be even.
J
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 9