Connect The Drain Hose - Infiniton WM-K10IN Manual De Usuario

Ocultar thumbs Ver también para WM-K10IN:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Install Washing Machine
Connect the inlet hose
1.Connect the inlet hose to tap and
fasten it anticlockwise.
2.Connect the other end of the inlet hose to the inlet valve at the backside
of the washing machine and fasten the hose tightly clockwise.
when there is a inlet at the back of the machine,it must be connected to
a cold water supply.If there are two inlet valve,one is connected to a
cold water supply and the other is connected to a hot water supply.
Follow the indication of the picture below to complete the connection.
inlet valve for cold water
inlet hose for cold water
NOTE
If there is any leakage with hose after
the connection,then repeat the steps to
connect inlet hose.
Do not bend the hose.
Check for inlet hose connection carefully
before using the washer each time.

Connect the drain hose

The drain hose shall be placed at a
height of 65-100cm above the floor,
otherwise,it can cause poor drainage
You can use the supplied drain hose
support bracket to loop the drain hose
down into the wall,standpipe or laundry
tub.
Take care to ensure all hose connections
are tight.
NOTE
The end of the drain hose cannot be
immersed in water for the washer to work
properly.
inlet valve for hot water with a red grid
inlet hose for hot water with a red side
8

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido