Installation; Product Description - Infiniton SD-8NDP El Manual Del Propietario

Ocultar thumbs Ver también para SD-8NDP:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION

Product Description

Top board
Container
Power Cord
Drum
Lint filter
Note: Please see the products you purchased in kind prevail.
Accessories
The following parts are optional
for specific models.
If your dryer has following parts,
please wear gloves and install them
following the instruction below .
Installation
Packing the dryer machine
Unpacking the dryer machine
Warning!
Packaging material (e.g. Films, Styrofoam) can be dangerous for children.
There is a risk of suffocation ! Keep all packaging well away from children.
Control Panel
Door
Air inlet
Handle
Maintenance cover
Hose holder(optional)
Condensing drain
hose(optional)
7
INSTALLATION
Use pliers to remove
Insert the
the drain hose from
external
the hose connector.
drainage hose.
Transport
Move cautiously. Do not grasp any salient parts of machine. The machine door can not be
used as the handle for delivery.
Installation Position
1.It is recommended that, for your convenience, the machine is positioned close
to
your washing machine.
2.The tumble dryer must be installed in a clean place, where dirt does not build up.
Air must be able to circulate freely all round the appliance. Do not obstruct the
front air inlet or the air intake grilles at the back of the machine.
3.To keep vibration and noise to a minimum when the dryer is in use, it should be
placed on a firm and level surface.
4.The feet must never be removed. Do not restrict the floor clearance through
deep pile carpets, strips of wood or similar. This might cause heat built-up which
would interfere with the operation of the appliance.
Level Adjusting
Once in its permanent operating position,
check that the dryer is absolutely level with the aid
of a spirit level. If it is not, adjust the feet with a tool.
Power Supply Connection
1.Make sure that the voltage of the power supply is the same as the electric specification
of the dryer.
2.Do not connect the dryer with the power connection board, the universal plug or socket.
Put the hose holder on the washing
basin or any other sink.
8

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido