Publicidad
4 Insert the Arm Assembly in the Mount Plate and turn it toward the direction you
want.
Arm Assembly
Mount Plate
5 Using the given 4 Machine Screws, join the Fixing Bracket to the Mount Plate.
6 Loosen the 2 screws shown in the figure below to adjust the arm length of the
Arm Assembly.
After adjusting the length, tightly fasten the screw to secure it.
`
7 Take out the Rubber Holder from the inside of the bottom of the Arm Assembly.
8 After separating the Rubber Holder from the Cap Installer, plug the Network
Cable in the Cap Installer.
Rubber Holder
9 Peel off the tape that holds the cable connected to the top part of the Arm
Assembly, and then pull the cable to drag the Network Cable.
10 After aligning the installation direction guides of the camera and Parapet Mount,
push the main cover upward and turn it counterclockwise until it is secured.
`
Install the camera according to the camera's installation guide.
11 Tightly fasten the 3 mounting screws on the Parapet Mount.
Fixing bracket
Machine screw
12 Using the Hex. L Wrench, loosen the screw shown in the figure below to adjust
the direction of the camera.
`
After adjusting the direction, tightly fasten the screw to secure it.
13 Join the cover of the Parapet mount using the screw bit included.
Cap Installer
Cover
Mount Plate
* The Parapet Mount contains a Hanging Mount. You can remove the Hanging
Mount to use it separately, or you can install another mount or camera that has a
screw thread of 1.5" PF to the Parapet Mount.
Product Specifications
Product Name
SBP-156LMW
XNP-9300RW / XNP-8300RW / XNP-6400RW
Supported product
* models can be added without notice
Color / Material
White / Aluminum
RAL Code
RAL9003
Product dimensions
1,116(Max.) x 1,000 x 95 (43.9(Max.) x 39.4 x 3.8")
(WxHxD) / weight
/ 7.1 kg (15.7 lb)
Product Overview
mm[inch]
PT01-005682A
Publicidad
