Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE CALLING
FOR SERVICE (continued)
Staining
Washer will nat turn ON
iiiiiiii'i _!i_i_i_i_!_!_i_i_!_i!_i!_i!_i!_i!_i_i!_i_!!i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i!_!!_
_'_i_iiii_ili_i_i_!i!i!_i_i_i
_i!iii_i_i
_ili _i_ii_ii_iiiii!!il
_!!_i_i_i_ii!:i_i_i
_'_ii_!i_!i_iiiiiiiii!!iiiiiiiiiiiiiiiii!!iii_i
_'I_
_i_iii!iiiiii_!iiiii!_i_i_ii_iiiii!!!ii!!ii!i
_ili_iiii!ii!i_i!iiiiiii!!!_i'i
_i_i!_i_i_i_i_i_i_i_i_i_i_!_i_iiiiiii_ii_iiiiiii_ii_iiiiiii_ii_iiiiiii_ii_iiiiiii_ii_iiiiiii_iii!!_i_i
Poss
uS
Bleach or softener dispensed
too soon.
Bleach or softener was added
directly
to the wash load in the drum.
Washer was not unloaded
promptly.
Clothes were not properly
sorted.
Door wlll nat unlock
when cycle is stopped or
paused
Wash cycle time islonger
than usual
Musty or rnildew/odor
in
washer
Wrinkling
Power cord is not properly
plugged
in.
House fuse is blown, circuit breaker
has tripped,
or power outage has
occurred.
House fuse is blown, circuit breaker
has tripped, due to multiple
appliances
on one outlet.
Interior temperature of washer is too high.
Water
level in washer is too high.
The washer automatically
adjusts the
wash time for the amount of laundry,
water pressure, water heating time and
other operating conditions.
Incorrect or too much detergent
has
been used.
iii!ii i ii ii ii ii iii!i!!i!!! iii!iii ii ii! !! ! i! i! i ! ! ! ! !
Dispenser compartment
is overfitted
causing
bleach or softener to dispense immediately.
Dispenser drawer closed too quickly
causing
bleach or softener to dispense immediately.
Laundry chemicals must be loaded into the
dispenser.
Always remove items from the washer as soon
as possibte after the cycle is complete.
Always wash dark colors separately
from light
colors and whites to prevent discoloration.
Never wash heavily soiled items with lightly
soiled items.
Make sure that the plug is plugged securely into
a grounded,
3-prong,
120-VAC, 60-Hz outtet.
Reset circuit breaker or replace fuse. Do not
increase fuse capacity,
if the problem
is a circuit
overload,
have it corrected
by a qualified
electrician.
Reset circuit breaker or replace fuse. If more
than one appliance
is connected
to the outlet,
call an electrician
to have an additional
circuit
installed.
The washer door has a safety feature to prevent
personal injury. For example,
if the washer is
paused during the hot wash stage of a sanitize
cycle, the interior temperature
of the drum will
be very hot, so the door will not unlock. This
is normal. Allow the washer to coot until the
DOOR LOCI( indicator
turns OFF on the display.
To drain the water, press POWER, then press the
SPIN SPEED button without
selecting a cycle.
This is normal. The washer adjusts cycle time auto-
matically to provide optimal results for the selected
cycle. The time remaining shown in the display is only
an estimate. Actual time may vary.
Use only High-Efflciency
(HE) detergent
in
accordance
with the manufacturer's
instructions.
Inside of drum was not cleaned
prop-
Run the CLEAN WASHER cycle regularly. Be sure
erty.
to wipe around and under the door seat fre-
quently. See Care and Cleaning
of the Interior.
Washer not unloaded
promptly.
Washer overloaded.
Hot and cold water inlet hoses are
reversed.
Ctean around door seal/glass to prevent odor.
Always remove items from the washer as soon
as the cycle is complete.
When washing large loads, do not overstuff the
drum. The washer can be fully loaded,
but the
drum should not be tightly packed and the door
should close easily.
Hot water rinse can set wrinkles in garments.
Check the inlet hose connections.
29
Publicidad
Tabla de contenido
