Technical Specification - J.P. SELECTA AUTESTER P 1.5 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80221 REV 0
J
.P. SELECTA s.a.
June/07
6 Operation
1. Switch on the autoclave. Main switch.
2. Open the chamber door. Remove the baskets.
3. Place the load into the basket. Insert on the chamber. Close the door and lock.
Rotate handler 1/4 turn.
4. Select a cycle. (121ºC, 134º). Press Start.
5. If water light is ON, add water on the reservoir.
6. The unit goes along the different phases, until END indication.
7. Open the door to remove the load from the chamber.
8. The unit is ready for another cycle.
Note:
To avoid problems caused by dirty:
• Clean the goods before to sterilize it.
• Specially clean free form oil and grease.
Caution: On unloading material from autoclave.
Hazard of burns to be in contact with hot surfaces.
Temperature in this area can exceed 100ºC.
Use the tray holder to load or unload the tray with instruments in it in order to
avoid burning injuries.
7 Technical specifi cation
Mains voltage:
Electrical power:
Maximum consumption:
Fuses:
Weight (Net):
Dimensions: W x L x H
Chamber volume:
Chamber dimensions
Water reservoir volume:
Ambient conditions:
Overvoltage category:
Pollution degree:
Door and front material:
Carriage material:
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta @jpselecta.es - website: http://www.jpselecta.es
(It can be modifi ed without notice)
230V 50Hz (See plate)
Other power supply voltage could be
available (Ask to your dealer)
1100W (See plate)
8.5 A
8A 20x5Ø mm
17.2 Kg
200 x 340 x 450 mm
1.5 Litre
Ø 90mm x 160mm
1.5 litres
Inner use.
Altitude up to 2000m
Temperature from 5ºC to 40ºC.
Relative maximum damp 80%for above
31ºC temperatures, decreasing lineally to
50% for 40ºC.
Category II
2
ABS injected
Aluminium
Tel 34 937 700 877 Fax 34 937 702 362
Page: 13