Taurus SLIDING CARE NON STOP 2500 Manual Del Usario página 14

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
- 2. To avoid any risk of burns/scalding, do not
adjust the angle if the device is still plugged in
or immediately after use.
FUNCTIONAL CHARACTERISTICS
- Safety pressure relief device (Fig 11)
- Pressure relieve valve opening
- When steam pressure in the heating body
becomes too high, the safety pressure relief
device on the base of the main body automati-
cally relieves pressure.
- To avoid any risk of burns/scalding, pay atten-
tion when using the high-temperature steam
spray.
PRE-HEATING AND STANDBY
- 0 seconds: Power on, pre-heating time
starts: temperature setting 1: Approxima-
tely 15 seconds. temperature setting 7:
approximately 40 seconds
- About 40 seconds: After finishing steam
preheat for about 40 seconds, press the
steam switch to enter into the steam iro-
ning operation mode.
- About 1800 seconds: The machine automa-
tically switches off after 30 minutes
OPERATION
- Filling the water tank:
- Remove the water filler plug, pour about 1.2l
water into the water tank, and refit the water
filler plug, pressing tightly.
- Tip: For maximum performance and a longer
service life, it is best to use purified water. (Fig
12)
- Purified water
- Assemble
POWERING UP AND PRE-HEATING
- 1 Switch on the power supply, the main body
"beeps".
- 2 Press and hold the power switch on the main
body for about 1 second to start the steamer, it
"beeps" and the power light comes ON;
- 3 After connecting the power supply, the
indicator flashes, as shown in the diagram, (in-
dicating the pre-heating process), this remains
ON constantly after finishing the pre-heating
process;
- 4 Use the steam setting and temperature set-
ting switch to select the desired settings based
on ironing needs
FOLDING THE IRONING BOARD (Fig 13)
- Ironing clothes
- 1 Steam ironing clothes (rotate the nozzle 90
degrees)
- Set the temperature to 200°C or 180°C, the
steam ironing function cannot be used at any
other temperature settings. The steam setting
can be selected by the user as required, when
the temperature indicator lamp stops flashing,
press the steam button switch to steam iron.
While ironing, use one hand to pull the clothes
taut, and the other hand to hold the steamer,
iron the clothes from top to bottom, several
passes of the iron may be required for heavier
garments.
- 2 Dry ironing clothes
- Select an appropriate temperature depending
on the fabric to be ironed, place the fabric to be
ironed onto the ironing board, use your hands
to smooth out any initial creases and slowly pull
the clothes taut and then iron slowly.
- During ironing, start in a small area slowly wor-
king out to a larger area. Always iron according
to different fabric and temperature instructions
on the care label, or use cloth or towel placed
over the garment when necessary.
- 3 Ironing reference table

Publicidad

Tabla de contenido
loading

Tabla de contenido