Klein Tools Toner-Pro Tone Generator Manual De Instrucciones página 5

FIG. 1
TRACING NON-PAIRED WIRES (FIG. 2)
1. Connect the Toner-Pro's red ABN Test Clip
2. Connect the black ABN Test Clip
not in the same pair (connect to ground, if available). When tracing a shielded
cable, connect the red ABN Test Clip to the outer shield, and the black ABN Test
Clip to the center conductor or ground.
3. Turn Toner-Pro on by pressing the Power On/Off button
4. Check the "CONT" Indicator
5. Turn on the Probe-Pro (sold seperately).
6. Select the preferred tone setting using the Tone Mode Up
Down selector buttons.
T7
7. At the far end of the cable, spread the wires at least 2" (51 mm) apart, if possible.
8. Use the Probe-Pro (sold seperately) to scan the cable's wire pairs. Move the
Probe-Pro's tip slowly across the wires. The Probe-Pro's volume will increase
as it approaches the toned wire.
FIG. 2
OPERATING INSTRUCTIONS
VDV500-123
(sold seperately)
to another wire in the cable, but preferably
T14
. If illuminated green, you may proceed.
T4
VDV500-123
(sold seperately)
(51 mm)
to the wire to be traced.
T14
.
T9
T8
(51 mm)
2"
or Tone Mode
2"
5