Klein Tools Toner-Pro Tone Generator Manual De Instrucciones página 6

ENGLISH
RJ11 / RJ12 / RJ45 TESTING
The Toner-Pro has an RJ11 Test Plug
ABN clips to transmit the tone. The RJ11 plug works with RJ11, RJ12, or
RJ45 jacks. The red and black ABN contacts are replaced by the 2 center
conductors of the inserted plug, i.e. pins 2 and 3 for RJ11, pins 3 and 4 for
RJ12, and pins 4 and 5 for RJ45.
Use the Probe-Pro (sold seperately) to locate the toned wires at the far end of
the cable, as described in the TRACING PAIRED WIRES section.
POLARITY AND VOLTAGE PRESENCE TESTING
The Toner-Pro may be used to test the polarity and type of voltage present.
1. Press the Power On/Off button
2. Press the TEST/TONE Select button button
will illuminate.
T1
3. Connect the ABN Test Clips
4. Check the "CONT" Indicator
5. The "NRM" (Normal) Polarity Indicator
Test Clip is connected to the POTS (Plain Ol' Telephone Service) in the
T14
proper orientation. The "REV" (Reverse) Polarity Indicator
if the wires are reversed.
• The "NRM" (Normal) Polarity Indicator
ABN Test Clip detects higher voltage than the red ABN Test Clip.
• The "REV" (Reverse) Polarity Indicator
ABN Test Clip detects higher voltage than the black ABN Test Clip.
• The "NRM" (Normal) Polarity Indicator and "REV" (Reverse) Polarity
Indicator will both illuminate when AC voltage is present.
• When the RJ11 Test Plug is used, the "NRM" (Normal) Polarity Indicator
will illuminate on a correctly wired and powered POTS (Plain Ol'
Telephone Service) phone jack.
NOTE: The POTS (Plain Ol' Telephone Service) color code convention
(black/positive, red/negative) is the opposite of the multimeter color
code convention (red/positive, black/negative).
6
OPERATING INSTRUCTIONS
on the Toner-Pro.
T9
, or insert the RJ11 Test Plug
T14
. If illuminated green, you may proceed.
T4
that can be used in place of the
T13
. The "TEST MODE" indicator
T10
will illuminate if the red ABN
T2
will illuminate when the black
T2
will illuminate when the red
T3
.
T13
will illuminate
T3