Intended Use; Charging Procedure - Ratio PRO XF20-P Manual De Instrucciones

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for
drilling without impact in wood, metal, ceramic
and plastic. Any other use is deemed to be a
case of misuse.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK (SEE
FIG A1)
Depress the Battery Pack Release Button (7)
firmly first and then slide the Battery Pack out
from your tool.
A1
C) TO INSTALL THE BATTERY PACK (SEE
FIG A2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
A2
D) CHARGER(ACG18LD3)
CHARGING YOUR BATTERY PACK (See Fig.
B1, B2, B3)
Do not use any charger other than that
specifically provided for use with the
equipment.
If the battery pack is very hot you must
remove your battery pack from the charger
and allow time for the battery to cool down
before recharging.
Please charge the battery to reach full before
storage. If the tool will not be used for long
periods of time, charge the battery every 3
months.

CHARGING PROCEDURE

1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger,
make sure the battery is in the
correct charge position firmly. the light will
turn to red to indicate the charging
process has started.
3) When charging is completed, the light will
turn to green.
4) After fully charged, unplug the charger and
remove the battery pack.
NOTE:
If the battery pack is locked in the charger,
press the battery pack release button and
remove it.
WARNING: When battery charge runs out
after continuously use or exposure to direct
sunlight or heat, allow time for the tool to
cool down before re-charging to achieve the
full charge.
39