Kohler K-7322 Guia De Instalacion página 4

Spout
2. Install the Faucet Assembly
Slide the mounting plate onto the faucet shank.
Align the groove in the underside of the faucet shank with the
setscrew hole in the mounting plate and secure with the setscrew.
Temporarily install the faucet onto the supply until the mounting
plate is both flush with the wall and the setscrew is facing down.
With a pencil, mark the location of the four mounting holes.
Remove the faucet from the supply.
Remove the mounting plate from the faucet shank.
Drill a 1/4" hole at each of the four marked locations.
Install an anchor into each of the four holes.
Apply thread sealant to the supply pipe threads.
Slide the gasket and mounting plate over the supply and up
against the finished wall. Position the mounting plate so the
setscrew hole is facing down.
Line up the holes in the gasket and mounting plate with the
anchors and secure with the four screws.
1047606-2-B
Finished Wall
Anchor
Supply
Mounting Plate
Escutcheon
Shank
Small
Setscrew
4
Gasket
Setscrew
Screw
Kohler Co.