Installation Instructions; Technical Data - Truma BCU 120 Guia De Inicio Rapido

Low-voltage warning device
Intended use
The Panel BCU (120) is a visual and acoustic low-voltage
warning device available as an accessory for the battery moni-
tor BCU 120. The device is designed for installation in cara-
vans, campers and boats.
Description
A flashing LED (Fig. A - 1) warns that the consumer is about
to be shut down at approx. 11 V. An intermittent tone signal-
izes that the consumer has been shut down at approx. 10.8 V.
Taking into operation
The device is operational as soon as the connection cable is
inserted and the battery monitor BCU 120 is operated.
Maintenance
Clean the device with a dry and fluff-free cloth.
Repairs
Do not repair or modify the device. Please contact your dealer
or the Truma Service (see service manual or www.truma.com).
Disposal
The device must be disposed of in line with the administrative
regulations of the respective land in which it is used.
National regulations and laws (in Germany, for example,
the Altfahrzeug-Verordnung [old vehicle directive]) must be
observed.

Technical data

Front plate
Aluminum
Ambient temperature
-20 °C to +50 °C
Width
58 mm
Height
40 mm
Depth
25 mm
Weight
50 g
The right to effect technical modifications is reserved!

Installation instructions

Safety instructions
Only qualified technicians may assemble and connect electri-
cal devices!
Ensure that the power supply has been disconnected! Discon-
nect the mains plug!
Only use the supplied lines and parts to connect the panel.
Only use suitable and fully functional tools.
Only wire the device as specified in the supplied wiring
diagram!
Installation
Installation in vehicles must accord with the technical and
administrative provisions of the individual country of use
(e.g. EN 1648). The national legislation and regulations must
be observed.
In other countries always observe the respectively valid
regulations.
Remove the equipment pack (accessories) and check it is
complete:
1 instructions for installation and use
1 connection cable, 5 m long
2 mounting screws
Install the panel in a place that is protected from damp and wet.
Cut out an opening (30 mm x 39 mm) for the device.
Connect the device and the battery monitor BCU 120 with the
supplied cable as specified in the wiring diagram (Fig. B).
Attach the device with the supplied screws.