Descargar Imprimir esta página

Grounding Instructions - HoMedics Body Basics SoleTherapy ST-2 Manual De Instrucciones E Información De Garantía

Masajeador de burbujas

Publicidad

Idiomas disponibles

Idiomas disponibles

• This product should NEVER be used by any individual suffering
from any ailments that would limit or altogether inhibit the user's
capacity to feel or have any sensation in the body part that the
product is being used for.

Grounding Instructions

This product must be grounded. If it should malfunction or breakdown,
Grounding Pin
grounding provides a path of least resistance for the electric current to
Figure A
reduce the risk of electric shock. This product is equipped with a cord
having an equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local codes and ordi-
nances.
Tab for
DANGER
Grounding
Adaptor
Screw
Improper connection of the equipment-grounding conductor
Figure B
can result in a risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to whether the
Grounded
product is properly grounded. Do not modify the plug provid-
Outlet
ed with the product - if it will not fit the outlet, you may tem-
porarily use an adaptor (such as the one shown in Figure B)
until you have a proper outlet (such as the one shown in
Figure C) installed by a qualified electrician.
Figure C
This product is for use on a nominal 120-volt circuit, and has a
grounding plug that looks like the plug illustrated in Figure A. A
temporary adapter that looks like the adapter illustrated in Figure B
may be used to connect this plug to a 2-pole receptacle as shown in
Figure D if a properly grounded outlet is not available. The
temporary adapter should be used only until a properly grounded
Metal Screw
outlet Figure C can be installed by a qualified electrician. The tab for
Figure D
grounding screw Figure B extending from the adapter must be
connected to a permanent ground such as a properly grounded
outlet box cover. Whenever the adapter is used, it must be held in
place by a metal screw. See Figures D and E.
Sole Therapy Features
Figure E
• Invigorating Massage Action to Soothe Away Stress
• Massage Rollers - Glide your feet back and forth to roll away
stress
• Foot Activated Controls - Just a touch of the toe turns bath
on and off
• Acupressure Surface - Tiny nodules stimulate your feet
• Soothing Heat - Helps to maintain warm water temperature
4
Instructions for Use
Caution:
To avoid injury
1. Ensure that the unit is unplugged before filling with water.
and irreparable
Fill with warm water to the fill line located on the inside side
damage, always
of the tub (See Figure 1). Do not fill higher than fill line (ap-
remain seated
proximately 2" from the top edge).
when using
2. Plug the unit into a 120 volt household outlet.
this foot bath.
3. To turn unit on, press the on/off button once. To turn off,
Never stand on or
press button again.
in the unit.
4. Sit down and place your feet in the spa.
5. If preferred, you can insert the rollers into the base of the
CAUTION: THIS
footbath (See Figure 1). Then, enjoy a deep penetrating
UNIT CAN ONLY
massage by sliding feet back and forth over the massage
rollers.
RUN WITH
WATER IN IT. DO
6. To empty: First, unplug the unit. Tip the unit, allowing water
NOT USE WITH-
to spill out along the drain spout, DO NOT pour over the
control button.
OUT WATER.
Maintenance
To Clean
Unplug the unit and allow it to cool before cleaning. Clean
only with a soft, damp cloth and mild cleansing agent.
• After cleaning, wipe surfaces with a dry cloth.
CAUTION:
DO NOT FILL WATER
• Never use strong abrasives, detergents or cleansing
OVER THE FILL LINE
agents.
• Periodically straighten cord if it becomes twisted.
To Store
Unplug the appliance from the outlet and allow to cool.
• Store in its box or a clean, dry place.
• To avoid breakage, do not wrap the power cord around the
unit.
• Do not hang the unit by the power cord.
• This appliance is designed for household use only.
Figure 1
5

Publicidad

loading