Cequent Performance Products 75750 Instrucciones De Instalación

Frame rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75750F
Wrenches: 18mm
Drill Bits: None
Tie Down Bracket
Note: Fasteners typical both sides
1 1 1 1
Qty. (6) Bolt M12 X 1.25 X 35mm
1. Remove Tie down brackets and return to customer.
2. Raise Hitch into place and Install the six (6) M12 fasteners and Conical Washers as shown above.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2012, 2013 Cequent Performance Products
Installation Instructions
Infinity JX
Nissan Pathfinder
Fascia
Tighten all M12 Cl8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1, SUV2
2 2 2 2
Qty. (6) Conical Washer
Sheet 1 of 3 75750N
Part Numbers:
75750
44679
87625
Max Gross
Trailer WT (LB)
Do not use
with spring bars with spring bars
3500 (1589 Kg) 525 (238 Kg)
Frame and Existing weld nuts
2
1
2-25-13
Max Tongue
WT (LB)
Do not use
Rev. B