Publicidad
Idiomas disponibles
Idiomas disponibles
Frame Rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75904F
Wrenches: 17mm, 19mm
Figure 1
Figure 2
j
Qty. (8)
Hex Bolt, M12 x 1.25 x 40mm CL 10.9
1.
Before installing the hitch, uninstall the hook (Fig. 1) by removing two bolts (Fig. 2) with a 17mm wrench. The hook is located on driver-side frame rail only.
Return the hook to vehicle owner.
2.
Raise hitch into position. Use supplied bolts and conical washers from the fastener kit to install the hitch. The bolts will go through the slots on brackets into
existing weld nuts.
3.
Torque all fasteners to correct torque specifications shown below.
Note: Check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water
and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do
not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©
2014 Cequent Performance Products, Inc. Printed in Mexico
Installation Instructions
Bumper Fascia
Existing weld nuts
j
k
Tighten all M12 x 1.25 CL 10.9 fasteners with torque wrench to 130 Lb.-Ft. (176 N*M)
Toyota Prado
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3
Vehicle frame
j
k
Note: All Fasteners Typical Both Sides of Vehicle
k
Conical Toothed Washer, 1/2"
Qty. (8)
Sheet 3 of 3
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
5500 (2500 Kg)
5500 (2500 Kg)
j
k
75904N
12-08-14
75904
Max Tongue
WT (LB)
825 (375 Kg)
825 (375 Kg)
Rev. A
Publicidad
