NSK Ti-Max X Serie Manual De Operación página 6

Insertion & Removal of the bur
TO INSERT THE BUR (Fig. 2) TO REMOVE THE BUR (Fig. 3)
Depress the Push Button and insert Stop the handpiece. Depress the
the bur into the chuck until it is Push Button firmly and remove the bur.
secure. Release the button.
6
Fig. 2
Caution
Test that the bur is secure by gently
pulling and pushing the bur without
depressing the Push Button. This action
can also increase the chuck retention
power. If removing the bur becomes
difficult, depress the Push Button,
grip the bur with fine pliers and gently
remove the bur.
Fig. 3
Information about burs
• Do not use non-standard burs. The ISO standard shank diameter is ø1.59 - ø1.60 mm.
• Do not use bent, worn, damaged, or non-concentric burs. Such burs can cause damage to the handpiece.
• Do not exceed the bur speed recommended by the bur manufacturer.
• Always keep the bur shank clean. Entry of hard debris into the chuck via the bur shank could cause
rotation slip and also prevent the bur from being securely located in the chuck.
• Fully depress the Push Button and insert the bur into the chuck until it is secure.
• Do not use short shank burs in Standard Head or Torque Head handpieces.
• Use short shank burs only in Mini Head handpieces.
• Do not use long surgical burs. Do not use burs longer than 26mm.
7