Cequent Performance Products 76025 Instrucciones De Instalación página 5

1.Appearance bottom panel and mud flap removal - use phillips screwdriver, panel removal tool, and 10 mm socket to remove (3) rivets,
and (2) bolts from bottom panel on driver side. Remove the mud flap each side if present. Keep the bottom panel and mud flaps for
reinstallation.
2. Bumper fascia removal - use panel removal tool to remove (2) plastic rivets from center
bottom fascia. Use phillips screwdriver and 10 mm socket to remove (4) bolts from wheel well
liner each side. Open the trunk and use 3/16'' hex bits to remove (2) screws each side, see
Figure 3. Using plastic trim tools, gently remove the plastic fascia starting at the outer edges
near the wheel wells. Disconnect the wiring from fascia if equipped.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 5 of 18 76025NP 03-31-17 Rev. A