MSA FASIT Gallet F1 XF Manual De Funcionamiento página 8

Adjusting the Helmet
WARNING!
The helmet only meets the retention requirements of EN 443:2008 when the chin strap provided by the
helmet manufacturer is worn and adjusted according to the instructions.
3.3 Visors
WARNING!
Visors worn over non-designated corrective frames may transmit impacts which may damage the
corrective eyewear thus creating a hazard to the user.
Service life of visors is depending on the conditions of use.
Any face shield that has been scratched, dropped or damaged must be replaced.
The visor type "Face guard" will provide protection to the eyes and substantial areas of the face.
Performances of the visor are obtained only in use position (low position). Visors should be in
standby position (stored under the helmet shell) during the use of a breathing apparatus (SCBA).
Equipment not marked with "T" should only be used at non-extreme ambient temperatures.
Ensure that you are using an EN443 helmet with a visor marked "+" for structural firefighting.
Materials that come in contact with the wearer's skin could cause allergic reactions in susceptible
individuals.
Face Shield
Ocular Visor (optional)
GB
The ocular visor can be adjusted to optimize the distance between visor and face.
8
- Via Orsera 13/b - 34145 TRIESTE - ITALY - Tel +39 040 825604 -
(1) Position by pulling it completely up or down.
(1) Position by pulling it up or down.
(2) Tilt the ocular visor towards the face for an optimal fit.
www.fasit.it - info@fasit.it