Cequent Performance Products 75992 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Figure 2
①
②
1 st rubber
isolator
Scan for step by step
PHOTO installation
③
instruction or visit
http://www.cequentgro
④
up.com/qr-product.aspx
1. Lower exhaust by removing (3) rubber isolators as shown in Figure 1. Use exhaust support stand to prevent damaging muffler.
2. Remove (1) screw at the fascia center support and carefully push it toward impact bar as shown in Figure 2. Return (1) screw to owner.
3. Remove heat shield on both sides. Remove (3) screws,(1) plastic plug on both sides, and (1) plastic clip attaching wiring harness only on driver side.
4. Trim the tab off heat shield on both sides, as shown in Figure 3. Reinstall the heat shields without (2) screws which attach to the frame rails on each side. Return (4) screws to owner.
There is a wide notch on the outside end of both rails which allows pull wire ⑥ to enter. Use the kink wire method in Figure 4 to feed carriage bolt ① and spacer ② through notch on bottom of frame rails.
5.
Raise hitch into position over the exhaust and sandwich the heat shield between hitch and frame rail. Remove pull wires and loosely install conical washer ③ and hex nut ⑤ to the hitch.
6.
7. Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Using the rearmost hole on each side of hitch bracket as a template, drill 17/32'' holes through the frame rail. Repeat step 5 to feed the fasteners and secure the hitch with conical washer ③ and hex nut ⑤.
8.
9. Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
10. Raise the exhaust back into position.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 75992, 87682, 44764
Fastener Kit: 75992F
3 rd rubber
isolator
Heat shield
Fasteners
typical
both sides
Figure 1
2 nd rubber
isolator
Access notch at
the end of rails
Rear
Sheet 3 of 15
① Qty. (6) Carriage bolt
½-13 x 1.50 GR5
② Qty. (6) Spacer
.250 x 1 x3
③ Qty. (6) Conical washer
½''
④ Qty. (6) Het Nut
½ -13 GR2
⑤ Qty. (6) Pull wire
½-13
⑤
Kink Pull wire to keep
spacer independent of bolt
Figure 4
Figure 3
75992NP 03-26-15 Rev. B