Federal Signal Electraray 225XL Instrucciones De Instalación Y Mantenimiento

Model 225XL and 225XL-N
Electraray
®
Hazardous Location LED Warning Light
Installation and Maintenance Instructions
Warranty: This product's limited warranty can be found at www.fedsig.com/SSG-Warranty
Limited
Safety Messages to Installers and Users
instructions. Failure to do so may result in property damage, serious injury, or death.
• To avoid electrical shock hazards, do not connect wires when power is applied.
• To be an effective warning device, this product produces bright light that could be hazardous to eyesight. Do not stare
directly at the light. Rapid flashing could induce photosensitive epilepsy.
• Never alter the unit in any manner. Safety in hazardous locations may be endangered if additional openings or
alternations are made.
• WARNING - EXPLOSION HAZARD: Do not disconnect while circuit is live or unless the area is known to be free of
ignitable concentrations.
An Overview of the 225XL and 225XL-N: Models 225XL and 225XL-N
hazardous location warning lights are available in 24VAC/DC or self-detecting
120-240VAC. The units come standard in flashing mode and are field configurable
to steady.
These devices are intended for permanent installation and operation in
accordance with Title 46, Code of Regulations, Parts 110-113, or Title 33, Code
of Federal Regulations, Part 183, Sub-part I, Section 183.410, and the applicable
requirements of the American Boat and Yacht Council, Inc. and/or ANSI/NFPA 302,
"Fire Protection Standard for Pleasure and Commercial Motor Craft."
Certifications and Ratings:
• UL and cUL Listed for Class I, Division 2, Groups A, B, C and D; Class II Divi-
sion 2, Groups F and G; Class III; or non-hazardous locations.
• Type 4X, IP66 enclosure. Indoor or outdoor use.
• IP69K Compliant
• Marine Listed
• Model 225XL-N is NSF Certified (dome-up) for Splash Zones
and Non-food Zones to NSF/ANSI 2: Food Equipment.
• Electrical ratings: 0.38A (24VAC/DC), 0.21A (120VAC),
0.13A (240VAC).
• Certified Operating Temperature: -58°F to 150°F (-50°C to 66°C).
T-CODE AT MAX AMBIENT TEMPERATURE
UL/cUL Hazardous Location Rating
Class I, Division 2, Groups A, B, C, D
Class II, Division 2, Groups F, G
Class III
Products should be installed by a licensed electrician and follow all safety
:
40°C 55°C 66°C
T6 T5 T4A
T6 T6 T6
T6 T6 T6
Elliptical
Outer Dome
with 12"
Curvature
Radius
Fresnel
Lens
PCBA
Silicone
Gasket
Zinc Alloy
E-coated
Base
Elliptical
5.5"/ 139.7 mm
Outer Dome
with 12"
Curvature
Radius
LED
Lamp
Inner
Fresnel
Lens
1/2"
NPT Pipe
Mount