Automatic Search Method - Steren V0808 Manual De Instrucciones

Do not exceed more than 10 seconds between each step.
Otherwise, the remote control exit from the Program Mode and you
must start again.
This kit is ideal for electronic students or hobbyists because
Probably there are more than one code for your device, but only
it allows them to develop creativity in the programming of
one of them will control almost the total of functions, try to find the
this prototype of a mechanical system. This kit includes all
more appropriated code for your brand.
1.- Switch your device on (not in Stand By).
2.- Aim the remote control at your device during the automatic search
method.
3.- Press and hold SET button. Then press the corresponding key, to
program your desired device (TV, DVD, VCR, etc). The indicating LED
turns on.
4.- Release the keys. Press the SET button once again. The indicating
LED will be blinking and the search begins.
5.- Press POWER (1) constantly -256 times max *-, until your device
turns off. IF the equipment turns off, IMMEDIATELY release THE power
button.
6.- Press the button of the programmed device (TV, DVD, etc.). The
remote control store the code for your device and exit from Search
Mode.

AUTOMATIC SEARCH METHOD

ENGLISH-05