Tabla de contenido
Publicidad
Step 7
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (I) and lay it over your unit.
Make equal margins along all four edges of the BACK (I). Push
å
on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: Do not tap NAILS into the holes that line up over the
å
SHELF (H) at this time.
Fasten the SMALL BACK (J) to your unit using the NAILS (1N).
å
NOTE: The SMALL BACK (J) overlaps the BACK (I). Be sure to
å
tap nails in the holes that line up over the SHELF (H).
Using your hammer, gently tap four TACK GLIDES (12E)
å
into the bottom edges of the ENDS (C and E) and
BASE MOLDING (M34).
C
12E
www.sauder.com/service
These holes must line
up over the SHELF (H).
J
M34
E
For support, place packing
foam and magazines here.
418735
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(57 used in this step)
I
I
J
H
1N
Page 11
Publicidad
Tabla de contenido
