Sauder 418735 Manual Del Usuario página 13

Step 9
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (K) to the LEFT END (E) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (69K) and BACKPLATE (92K) to the
å
DOOR (K). Use a SILVER 1-1/2" MACHINE SCREW (95S).
Repeat this step for the other DOOR (K).
å
See the next step for DOOR adjustments.
å
SILVER 1-1/2" MACHINE SCREW
(2 used for the KNOBS and BACKPLATES)
www.sauder.com/service
Stop
Mounting
screw
Hinge
69K
92K
95S
K
E
418735
Pro Tip: Lift with your
legs. And, you know,
your arms.
Page 13