Kobalt KST 180-06 Manual Del Usuario página 16

ASSEMBLY INSTRUCTIONS
7. Connecting to power supply
Note: The power head is designed with a cord retainer
that prevents the extension cord from being pulled loose
while using.
a. Form a loop with the end of the extension cord
(not included).
b. Insert loop portion of extension cord through opening
in the bottom of the rear handle and place
over cord retainer.
c. Slowly pull loop against cord retainer until the slack is
removed.
d. Plug power head (A) into extension cord.
Note: Failure to remove all excess cord slack from
extension cord retainer could result in plug loosening
from receptacle.
8. Using the strap harness
a. Rotate the strap harness to the upward position.
b. Hook the strap (not included) to the strap connection.
1) 2-prong plug
2) Properly grounded extension cord
Strap
Connection
16