Optional Features - Hamilton Beach Proctor Silex 17130 Manual Del Usuario

840160700 Ev01.qxd 2/5/07

Optional Features

Auto Shutoff Reset
(on select models)
The light comes on when the iron is first
plugged in. After one hour, the iron will
shut off and the light will go out. Push the
Reset Button to turn the iron back on.
Power ON Light
On units not provided with Auto Shutoff,
this light comes on when the iron is
plugged in and remains on until the iron is
unplugged. The light stays on even if the
Temperature Control Dial is turned to
OFF ( O ).
Caring and Cleaning
Iron
1. Turn Temperature Control Dial to Off ( O ). Unplug and
let cool. The iron takes longer to cool down than it does
to heat up.
2. To empty water from iron, slowly tilt pointed end of iron
down over a sink. Water will run out of water tank opening.
3. Wrap cord loosely around iron and store iron in an upright
position. Do not store iron laying flat on soleplate.
9:00 AM Page 8
(on select models)
8
Caring and Cleaning
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps, as
these may scratch the soleplate.
2. To clean occasional build-up on the soleplate, wipe with
a sudsy cloth. Do not use abrasive cleansers or metal
scouring pads.
3. Always store iron upright in the heel rest position.
Self-Clean
To keep the steam vents clear of any build-up, follow these
instructions each time you iron using steam.
1. Turn Temperature Control Dial to OFF ( O ) and set
Adjustable Steam Switch to Dry Iron
water to 1⁄2 of its maximum capacity.
2. Turn Temperature Control Dial to Linen setting and let
iron heat for 2 minutes in the heel rest position. Keep
Adjustable Steam Switch on Dry Iron
3. Turn Temperature Control Dial to OFF ( O ). Unplug iron
and hold over a sink with soleplate facing down.
4. Turn Adjustable Steam Switch to Self Clean
rise up), while pressing Blast of Steam button often. Boiling
water and steam will flow out of steam vents. Allow all
water to drain from iron.
NOTE: Dial may lift all the way out of iron. To replace, align
tab on steam dial with slot on hole in iron, push down all
the way and twist clockwise.
5. Gently move iron front to back to allow water to clean
entire soleplate area.
6. When finished, push Steam Control dial down and turn
clockwise to take out of Self Clean mode.
9
(cont)
. Fill iron with
.
(dial will