Move Refrigerator To Final Location; Level And Align Refrigerator - JENN-AIR JS42NXFXDW Guia De Instalacion

Move Refrigerator to Final Location

WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
To avoid floor damage, make sure levelers are raised (not
touching floor) and refrigerator is on rollers before moving.
Use the installation block, attached to the door hinge, as a
reference to make sure the refrigerator is pushed back far
enough into the opening, so that when the panels are installed
they will be flush with the adjacent cabinets.
NOTE: A flush installation is not possible with a 24" (60.9 cm)
deep opening.
After the refrigerator is leveled and aligned, remove the
installation block from the door hinge and use it to check the
spacing between the panels and adjacent cabinets.
NOTE: The installation block is designed to provide accurate
spacing for ³⁄₄" (1.9 cm), ³⁄₈" (9.53 mm) and ¹⁄₈" (3.18 mm).
³⁄₄
"
(1.9 cm)
1. Place top of cardboard carton or plywood under refrigerator.
Remove dolly.
2. Move the refrigerator straight back and evenly into the
opening. Be sure that the water tubing is not kinked and the
power supply cord is on top of the refrigerator.
NOTE: If the power supply cord is behind the refrigerator, it
will not install properly.
18
3. Make sure the installation block is flush with the adjacent
cabinets.
NOTE: To achieve a flush installation, it is critical to verify a ³⁄₄"
(1.9 cm) depth from the front face of the adjacent cabinetry to
the refrigerator.
A
B
C
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
¹⁄₈
"
Use two or more people to move and install
(3.18 mm)
refrigerator.
³⁄₈
"
(9.53 mm)
Failure to do so can result in death or serious injury.
IMPORTANT: All four leveling legs must contact the floor to
support and stabilize the full weight of refrigerator. Rollers are for
moving the refrigerator, not for permanent support.
After moving the refrigerator to its final location:
1. Use a ⁵⁄₁₆" socket driver to turn the leveling bolts clockwise to
extend the legs to the floor as shown. The rollers should be off
the floor.
A B
³⁄₄
" (1.9 cm)
A. Adjacent cabinet or wall
B. Installation block
C. Face of refrigerator

Level and Align Refrigerator

WARNING
Tip Over Hazard
A. Rear leveling bolt
B. Front leveling bolt
A
B