English
14
Problem
The infrared
remote control
does not function.
The appliance does
not function and
the standby light on
the cover of the
appliance flashes.
When I use my
vacuum cleaner I
sometimes feel
electric shocks.
removing the postureprotect handgrip
If you do not find the PostureProtect handgrip comfortable to use, you can consider removing it.
1
Remove the screw cover strip from the PostureProtect handgrip. (Fig. 49)
2
Use a Torx T15 screwdriver to remove the screws of the PostureProtect handgrip (Fig. 50).
3
Remove the PostureProtect handgrip from the tube.
Possible cause
The nozzle, hose or
tube is blocked up.
You have not inserted
the batteries properly
or the batteries are
empty.
The dust bucket and/or
the filter cylinder unit
are not installed
properly.
The cover is not closed
properly.
Your vacuum cleaner
has built up static
electricity. The lower
the air humidity in the
rooms, the more static
electricity the appliance
builds up.
Solution
To remove the obstruction, disconnect the
blocked-up item and connect it (as far as
possible) the other way around. Switch on the
vacuum cleaner to force the air through the
blocked-up item in opposite direction.
Insert the batteries properly or replace them. See
chapter 'Replacement'.
Unplug the appliance. Make sure that the filter
cylinder is assembled properly into the filter
cylinder case ('click'). Also make sure that the
filter cylinder unit is inserted properly into the
dust bucket ('click').
Make sure the cover is closed properly. Put the
plug in the wall socket and try again.
To reduce this inconvenience, we advise you to
discharge the appliance by frequently holding the
tube against other metal objects in the room (for
example legs of a table or chair, radiator etc.).
To reduce this inconvenience, we advise you to
raise the air humidity level in the room by placing
water in the room. For example, you can hang
containers filled with water from your radiators
or place bowls filled with water on or near your
radiators.