DeWalt DW937 Manual De Instrucciones página 21

Director Engineering and Product Development
Horst Großmann
D WALT, Richard-Klinger-Straße 40,
E
D-65510, Idstein, Germany
Safety instructions
When using Power Tools, always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions
before attempting to operate this product.
Keep these instructions in a safe place!
General
1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Consider work area environment
Do not expose Power Tools to humidity.
Keep work area well lit. Do not use Power Tools
in the presence of inflammable liquids or gases.
3 Guard against electric shock
Prevent body contact with earthed surfaces
(e.g. pipes, radiators, cookers and refrigerators).
For use under extreme conditions (e.g. high
humidity, when metal swarf is being produced,
etc.) electric safety can be improved by inserting
an isolating transformer or a (FI) earth-leakage
circuit-breaker.
4 Keep children away
Do not let children come into contact with the
tool or extension cord. Supervision is required for
those under 16 years of age.
5 Store idle tools
When not in use, Power Tools must be stored in
a dry place and locked up securely, out of reach
of children.
6 Dress properly
Do not wear loose clothing or jewellery.
They can be caught in moving parts. Preferably
wear rubber gloves and non-slip footwear when
working outdoors.
Wear protective hair covering to keep long hair
out of the way.
17
7 Wear safety goggles
Also use a face or dust mask in case the
operations produce dust or flying particles.
8 Beware of maximum sound pressure
Take appropriate measures for the protection of
hearing if the sound pressure of 85 dB(A) is
exceeded.
9 Secure workpiece
Use clamps or a vice to hold the workpiece.
It is safer and it frees both hands to operate the
tool.
10 Do not overreach
Keep proper footing and balance at all times.
11 Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
12 Remove adjusting keys and wrenches
Always check that adjusting keys and wrenches
are removed from the tool before operating the
tool.
13 Use appropriate tool
The intended use is laid down in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended.
Warning! The use of any accessory or attachment
or performance of any operation with this tool, other
than those recommended in this instruction manual
may present a risk of personal injury.
14 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Inspect the tool cords at regular
intervals and, if damaged, have them repaired by
an authorized D WALT repair agent. Keep all
E
controls dry, clean and free from oil and grease.
15 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function.
Check for misalignment and seizure of moving
parts, breakage of parts and any other conditions
that may affect its operation. Have damaged
guards or other defective parts repaired or
replaced as instructed. Do not use the tool if the
switch is defective. Have the switch replaced by
an authorized D WALT repair agent.
E
E N G L I S H
en - 2