Kohler K-2191 Guia De Instalacion página 4

Spout
Centerline
1. Preparation
Install the water supplies and drain piping according to the
roughing-in information.
NOTE: The lavatory displayed in the illustration may differ from
your actual product.
Wall-Mount Bracket Installations
NOTE: Turnings and Conical Bell Vessels lavatories can be installed
on this wall-mount bracket. The Hex Strata is not suitable for
wall-mount bracket installation.
Install the lavatory according to the instructions packed with the
bracket.
Countertop Installations
Position the template on the countertop.
For Wall-Mount Faucets: Provide sufficient spout overhang into
the lavatory basin. The faucet spout length must be at least 5"
(12.7cm) to provide proper performance.
For Countertop Faucets: Pay special attention to the spout and
handle fit clearance when locating the faucet. Use the template to
locate the faucet spout hole centerline on the countertop. This
centerline is recommended to provide adequate clearance
between the edge of the lavatory and the spout.
1018373-2-A
Backsplash
1" (2.5cm)
Minimum
Clearance
Cut-out Line
Outside
Edge of
Lavatory
4 Kohler Co.