ARENDO 305029 Manual Del Usuario página 23

5. Installing the pressurised cylinder
Slide the pressurised cylinder into the compartment provided and tighten it.
Caution! Be careful when using gas cylinders!
Gas cylinders are pressurised and can explode if heated!
Therefore, please store them in a well-ventilated room!
Remove the mesh of the drip pan and then place the carbonator carefully on its
side with the knob facing up.
Remove the plastic seal from the top of the gas cylinder. Guide the gas cylinder
carefully through the hole at the bottom. Do not drop the cylinder into the hole.
If you feel that it has reached the bottom, start turning the cylinder clockwise
until it is fixed. Do not tighten too much as this could break the thread that holds
the gas cylinder in place.
When replacing the gas cylinder, place the carbonator on its side with the knob
facing up and remove it by turning counter-clockwise. Then take it out carefully
from the compartment.
23
English