ARENDO 305029 Manual Del Usuario página 26

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Water that is flushed through the machine during carbonation ends up in the drip
pan. This happens often if there is too much water in the water bottle. Make sure
that the water is not filled above the filling line and empty the bottle regularly.
9. Troubleshooting
Error
No gas or too little gas
comes out when the button
is pressed
When the button is pressed,
gas enters the bottle but
the water is not carbonated.
Gas starts to enter the ma-
chine when tightening the
cylinder even though the
button is not pressed
10. Safety instructions and disclaimer
Never try to open the appliance to repair or make modifications. Avoid contact
with the mains voltage. Do not short-circuit the product. The appliance is not
waterproof, therefore please use it only in dry surroundings. Protect it from high
humidity, water and snow. Do not expose the appliance to high temperatures.
Do not expose the appliance to sudden changes in temperature or strong vi-
brations. Check the appliance for damage before using it. The appliance should
not be used if it has been subject to impact or has been damaged in any other
manner. Please comply with the local regulations and restrictions.
26
Cause of error/ Troubleshooting
• Check if the gas cylinder is empty
• Try to tighten the cylinder a bit more and try
again. Some old cylinders require this to be
done.
• Make sure that you press the button down
fully (without applying too much force).
• Try to tighten the cylinder a bit more.
• Something could be wrong with the gas
cylinder seal.
• There may be a leak between the cylinder
and the machine. Try to tighten the cylinder
a bit more.
• Something could be wrong with the gas
cylinder seal.
English

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

20200930nb163

Tabla de contenido