Manual Configuration - D-Link DNH-100 Guía De Instalación Rápida

Interface Connectors
1 2 3
Figure 2: Front Connectors
# Connector
Used for rebooting or resetting
1 Reset
the device back to factory default
settings.
Console RJ-45 port to connect the RJ-45
2
Port
console cable for CLI management.
Ethernet
Gigabit RJ-45 por t for LAN
3
Port connection.
MicroSD
MicroSD slot for MicroSD card
4
Slot
up to 32 Gb.
USB 3.0 Type A port
5 USB Port 5V/1A power for optional HDD
connection).
Table 2: Interface Description
Installation
The DNH-100 can be powered using the
following methods:
Using the Power Adapter
1. Connect the power connector of the
adapter to the power input on the
DNH-100 and plug the adapter into a
nearby power outlet.
DNH-100 Quick Installation Guide
4 5
Description
2,3
(provides
2
Configuration
Using Nuclias Connect
The DNH-100 comes preloaded with Nuclias
Connect. For detailed instructions on the use
of Nuclias Connect please refer to the Nuclias
Connect Manual.

Manual Configuration

Note: D-Link recommends manually configuring
the device before mounting it. The management
computer, DHCP server and DNH-100 must be
in the same subnet.
Use one of the following methods to access the
web user interface:
Connecting through Ethernet
You need the following equipment to access the
Web UI of your device:
• A PC with a RJ-45 Ethernet connection
• A standard Ethernet cable
1. Use an Ethernet cable to connect the
DNH-100 to the management computer
or to the switch or router the management
computer is connected.
2. Manage the device from a computer. Enter
https://192.168.0.200 in the address field
of your browser.
3. Log in to the administration user
interface. The default login information is
Username: admin
Password: admin
3