Warnings And Cautions - Glacier bay N2428R-DF Manual De Instrucciones

WARNINGS AND CAUTIONS

• Handle with care. Vitreous chinaware is glass-like with sharp edges if broken. Do not drop, handle
roughly or overtighten bolts.
• Risk of hazardous gases. If new toilet is not installed immediately, temporarily plug floor flange hole
with a towel (or cover) to block sewer gases from escaping.
• Observe local plumbing and building codes.
PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with package
contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or
operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 minutes
Tools Required for Assembly and Installation (not included): Toilet Water Supply Line, Adjustable Wrench,
Putty Knife, Flathead Screwdriver, Hacksaw, Carpenters Level.
ASSEMBLY INSTRUCTIONS
Remove Old Toilet
• Turn off water supply and flush tank completely. Towel or sponge remaining water from tank and bowl.
• Disconnect and remove old water supply line.
• Remove tank from bowl by removing old tank-to-bowl hardware.
• Remove bowl from floor by removing bolt caps and floor bolt nuts.
• Remove floor bolts from toilet flange and clean old wax, putty and sealant from base area.
(Temporarily plug floor flange with a towel or cover to block sewer gases from escaping.)
• NOTE: MOUNTING SURFACE MUST BE CLEAN AND LEVEL BEFORE NEW TOILET IS
INSTALLED.
1. Install Floor Bolts (AA), (Fig. 1)
• Insert new floor bolts (AA) into the toilet flange
(not included) with bolt heads down and threaded
ends facing up (use plastic retaining washers (BB)
to hold bolts in full-length, upright position).
• Floor bolts (AA) should be parallel to wall and 6
inches apart.
AA
BB
3
Fig. 1
Toilet
Flange