PEERLESS ONEMount ONE-TP Instalación Y Ensamblaje página 6

For Flat Back Screen
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into screen as shown
2-3
below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten.
If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
If you have any questions, please call Peerless customer care at 1-800-865-2112 or visit our website at
www.peerlessmounts.com/5 to locate your screen compatibility chart.
For Bump-out or Recessed Back Screen
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
2-4
screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do
not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112 or visit our website at
www.peerlessmounts.com/5 to locate your screen compatibility chart.
SCREEN
SCREEN
SPACER
MULTI-WASHER
SCREW
ADAPTER
BRACKET
(BB or CC)
MULTI-WASHER
SCREW
ADAPTER
BRACKET
(BB or CC)
6 of 33
ISSUED: 09-20-06 SHEET #: 202-9167-4 11-13-07
fig 2.3
fig 2.4