Installation To Double Wood Stud Wall - PEERLESS ONEMount ONE-TP Instalación Y Ensamblaje

Installation to Double Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is
highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of mounting situations.
NOTE: If mounting equipment weighing greater than 200 lbs or if your screen size is in the 50" to 84" range, triple
stud mounting is strongly recommended.
Skip to page 9
4
Refer to chart below to determine wall plate configuration. Wall plate (AA) can be mounted to two studs that are 16"
apart. Use a stud finder to locate the edges of the studs. Use of an edge-to-edge stud finder is highly recommended.
Based on their edges, draw a vertical line down each stud's center. Place wall plate on wall as a template. The top
mounting slots should be 2.5" above the desired screen center as shown in figure 4.1. Level plate, and mark the
center of the four mounting holes. Make sure that the mounting holes are on the stud centerlines. Drill four 5/32" (4
mm) dia. holes 2-1/2" (65 mm) deep. Make sure that the wall plate is level, secure it using four #14 x 2.5" wood
screws (DD) as shown in figure 4.2.
NOTE: Wall plate may be mounted up to 4" (102 mm) off center as shown in figure 4.1.
Skip to step 5.
STUD
AA
2.5"
(64 mm)
CS = center of screen
Wall Plate Configurations
One Wall Plate
Two Wall Plates
Three Wall Plates (installation on page 9)
WARNING
4"
(102 mm)
CS
fig. 4.1
Screen Range
23"-37"
32"-50"
50"-84"
4"
(102 mm)
AA
Studs
2
2
3
8 of 33
ISSUED: 09-20-06 SHEET #: 202-9167-4 11-13-07
DD
fig. 4.2